This article explains how to enable the video replay functionality for a race in copernico.
Note: Video replay availability depends on both the race configuration and the control points where video capture is required.
Requirements to enable video replay
To make video replay available in a race, the following requirements must be met:
- The race must be configured in Live mode.
- The control points must have video replay enabled.
Enable Live mode
The first step is to ensure that the race is set to Live mode.
- Go to the race settings in copernico.
- Enable the Live option.
In this article you can see the process .
⚠️ Important: If Live mode is not enabled, video replay will not be available.
Configure video replay at control points
Once Live mode is enabled, you must configure the control points where video replay will be captured.
Steps:
- Go to the locations or control points section.
- Select the desired control point.
- Enable the video replay option.
This setting allows the timing device to record and display replay footage at that specific point of the race.
Comments
Article is closed for comments.