Using the reader for timing

To switch on the reader, press the button on the handle, the first (blue) light on the left side will start blinking, this indicates that the reader is searching for a bluetooth connection with a mobile device.


Once a mobile connection has been established through the app, bear in mind the following for consistent timing.

  • To read a tag, point the reader directly at it and press the button on the handle.
  • Hold the reader at a distance of 4 metres for disposable tags and 1.5 metres for multisport tags.


❗❗Holding the button for a prolonged time will run the battery out faster.
❗❗The sensor is not water resistant. In the case of rain, ensure that it is covered.
❗❗Be sure that the reader battery is fully charged before a race.
Was this article helpful?
0 out of 0 found this helpful



Please sign in to leave a comment.